CSW-200 High Traffic Commercial Swing Gate Operator from Scotland Entry Systems

Entry Systems, Inc.
Since 1985

CSW-200 High Traffic Commercial Swing Gate Operator

All CSW-200™ series swing gate operators are constructed with 1/4" sheet metal that is fully sanded, welded and gold zinc plated for rust proof protection. The covers are made from a 1/4" thick, unbreakable polyethylene plastic for long life. They are equipped with two gear boxes, both lubricated in an oil bath, equalling 900 to 1 gear reduction ratio.

NON-SCISSOR ACTION ARM
Most swing gate operator arms will cross and produce a dangerous "scissor" action while opening the gate to a 90°opening, as shown in picture "A". We designed our CSW-200™ operator arms to not cross, eliminating the scissor action as shown in picture "B". This feature reduces the risk of injury from the gate operator arm. the loop.

Specifications
Modular Board – Uses LEDs to indicate all input and output functions of the gate operator.

ERD – If the gate hits a vehicle while closing, it re-opens. If it hits a vehicle while opening, it stops, reverses 4 to 6 inches and stops again.

Digital Motor Protection – Entrapment sensor shuts off the motor after it reaches the stall amp for 3 seconds, reverses direction for several inches, and stops.

Electronic Inputs – Radio receiver, key switch, telephone entry system, computer input, fire dept. key switch & 3-push-button station.

Timer – Adjustable timer can be set from 3 to 60 seconds.
* Power Input On/Off Switch – Controls power input to the board with convenient switch.

Spike Suppressors – Fast response time (50 nanoseconds) when subject to an impulse surge (lightning strike) up to 100 amps.

Alternate Outputs – With Omni Option Board 3 push button command control, burglar alarm input and output.

Gate Traveling Time – Adjusted by a precision mechanical device and electrical limit switch system.

Soft Stop – Gate travels through the cycle at normal speed and comes to a stop slowly for more accurate gate cycle. Equipped with integrated time delay for long mechanical life expectancy.

Integrated Loop Detectors – Easy to install, modular, plug in loop detector.

Power Management – Board includes electronic power management with over current shutdown and automatic recovery.

Burglar Alarm – With Omni Option board, interfaces with existing home alarm or alarm output.

3 Push Button Control – On board gate operator control for close, stop, and open.

Motor Drive – Solid-State electronic motor drive system is incorporated into board.

UL Alarm – If the gate hits an object twice while opening or closing, the system will shut down and alarm will sound for five minutes. After five minutes the system will automatically reset itself. To reset the system during the five minutes, a manual reset button must be used.

120 VAC Power – Built-in 120 VAC power receptacle (NEMA 5-15).

For more information contact info@ScotlandEntry.com
Phone:	(818) 376-0777
Fax:	(818) 376-0719

adv_visa_sm.gif (357 bytes) AMEX.jpg (1763 bytes) mc_logo2.gif (1528 bytes)